The Airheads Beemer Club is a non-profit club reclaiming the 'Legendary Motorcycles of Germany'
Please take a moment to read the DISCLAIMER.

R100GS Dual Pot Caliper Upgrade

I've always been a believer in the old "if some is good, more is better" philosophy, especially when it comes to brakes. I'd already gotten a substantial improvement in stopping power with the big rotor conversion from M.A.P. Engineering, but when I heard on the Airheads mailing list that it was possible to fit the dual piston caliper from a later oilhead BMW I couldn't resist leaving well enough alone. I dug a little bit and found that the left caliper from an R1150GS, part number 34117670391, has the same mounting bolt spacing as the R100GS caliper, and would center over the rotor if about 0.10" of the boss thickness was milled off (several R11XX model BMW motorcycles use this same caliper). I fished around the IBMWR classified page for a used caliper, but some folks have an exadurated sense of worth for their old parts. A fellow lister suggested Cycles Recycled as a possible source, and Fred Rowland quickly answered an email inquiry with a $35 plus shipping offer I couldn't refuse. Two weeks later the part was in hand and I had to figure out how to get it to fit.

This remainder of this article is only available for Airheads Beemer Club members. Please Log In..or..Click Here to join the Airheads Beemer Club, after which you will enjoy access this article and all members only content of the ABC web site.